Vacancy expired!
CMM Programmer / Operator
We are look for seasoned / experienced CMM operator. The programmer / operator we are looking for should apply if you can meet the following requirements;
Has experience with CMM programmer software and preferably the Zeiss PRISMO CMM but not a must.
Should have experience with programing and operating to preform inspection of precision gages and fixtures.
It is preferred for the operator to have a understanding of Correlation between gage data and parts being measured on the CMM.
Must have a complete understand of GD&T
We are ISO 17025 accredited company with policies and procedures in place. The scope and uncertainty of the CMM and room has already been determined.
This position Reports to the Quality Manager
If you have the experience and are ready to work with growing company send your resume the email address listed.
Vacancy expired!